https://drive.google.com/file/d/0B2mvAu ... sp=sharing
It was running on Windows 7 32-bit, slowed down to 5kpps and TTL input of laser driver was connected to Channel A. Should I try different channel?
The laser is 200mW and I did not play with focus yet.
PacManFan, could you please implement UI element/command for manual switching of laser (on/off). It may help during focusing of the laser and aligning of X/Y axis. It may be done by disconnecting of TTL signal, however when the device is enclosed in a case, it might be useful. I also think that if the CW could render a continous square it might help to tune scale and galvo positions.
I see that Wabbe already started a build log. Could the rest of you please do the same? I will do that as well. We can inspire each other during design and construction
