this is good !!!!!!!!!!!!
Have galvo but i don't want to use without f theta lens.
Only on the middle you can print and slic3r don't have spot compensation.
Do anyone knows good f theta lesn for sale cheap and do the job.
see photo
Printy! A DIY Open Source 3D Printer!
Re: Printy! A DIY Open Source 3D Printer!
- Attachments
-
- 1402LFW_51.jpg (10.71 KiB) Viewed 10298 times
Re: Printy! TE Open Source da di fai 3D della stampante di una!
In a printer of this kind would serve a LAN connection, a slot for SD cards and a beautiful display.
For the rest is fantastic, I'd like to see in detail the board between the galvo and Arduino
For the rest is fantastic, I'd like to see in detail the board between the galvo and Arduino
Re: Printy! A DIY Open Source 3D Printer!
Repetier have lan connection and web Software it works put gcode on it and push start i try it works .
Re: Printy! A DIY Open Source 3D Printer!
@Gr3ymatter
Any updates?
Any updates?
Re: Printy! A DIY Open Source 3D Printer!
Goldi, if you do the math, then if you throw your laser over a distance of around 250mm, then you can get a 60-80mm square build area with little or no deviation. After that if goes bad quickly but 60x60mm is for example not a bad part to work with
Re: Printy! A DIY Open Source 3D Printer!
I calculate the form laser beam is 0.145 dot, wen is on 145mm or from middle 72mm the beam is like egg 0.185 dot.
Regards
Regards
Re: Printy! A DIY Open Source 3D Printer!
145mm is also 2.5 times 60mm 

Re: Printy! A DIY Open Source 3D Printer!
What happened to printy?
any updates?
any updates?