Build Your Own SLA/SLS

Here is something I printed last night. Took about 5 hours to print. Using a new formulation from MakerJuice. It had some strange holes develop on one side, not sure why they didn't appear on the other side or anywhere else because the walls are the same thickness throughout. The walls are very thin, probably too thin for this scale but turned out pretty well.

I did over sample the slices about 3.5x then scaled back down in Photoshop. There were 1389 slices total. Each layer exposed for 9.5 seconds - total layer time 13.5 seconds.

It actually looks way better than I thought it did. The side that turned out is pretty nice, forgot to ask what resolution (Z) did you print at?

hi watsonstudios,

very nice print

what kind of dimension is it?

it looks like 10cmx10cm

i've got my build plate ready today, 90mmx76mm
i'd love to give it a try

hp

Hi Watsonstudios,

That is a beautiful print! I'm very interested to test using over-sampled images. What process are you using?

Thanks,

Craig

No t to step on an toes but Jon has the process he uses listed in his build thread about 3/4 of the way down first page.



Clinton