Loving my top-down setup.
Posted: Wed Feb 25, 2015 6:47 pm
It seems like my top-down machine is complete and ready for printing lots of parts.
It is equipped with a wiper system, but I've noticed that if you give the resin enough time to settle you'll get great results.
The bracelet was printed with Makerjuice floating resin.
Z resolution was setup at 30 microns.
You can see a video of the printer here:
http://youtu.be/H3MCMx6IiBc
Thanks again everybody for your support and knowledge.
This forum is awesome!
It is equipped with a wiper system, but I've noticed that if you give the resin enough time to settle you'll get great results.
The bracelet was printed with Makerjuice floating resin.
Z resolution was setup at 30 microns.
You can see a video of the printer here:
http://youtu.be/H3MCMx6IiBc
Thanks again everybody for your support and knowledge.
This forum is awesome!