Build Your Own SLA/SLS

Hello,

I had an 4 inch screen and a Raspberry Pi of which I did not know what to do then I made one LCD SLA 3D Printer !
I was inspired a lot by the work of Ionel Ciobanuc









Description :
4 inch LCD Screen
Raspberry Pi 3
Arduino Mega & RAMPS 1.4
ProjectLayer
50 W 405nm LED

Parameters :
- Layer Thickness = 0.1mm
- Cure Time = 12 seconds
- Lift 20mm
- FunToDo Snow White Resin

The principle is so simple but the development, a little less!

Thank you all !!!

Jled.

How are you switching the 50W leds on/off ?

Hello,

I use a relay connected to fan output and I command light on/off with gcode command m106 et m107.

Cool dragon!