UV LCD SLA 3D Printer
Posted: Wed Jun 21, 2017 3:12 pm
I have successfully completed a UV LCD SLA 3D Printer.
Hardware:
- Raspberry PI 3
- LCD 5 inch 800x480 HDMI
- Drivers drv8825 (Microstep=16)
- Stepper+threaded rod
- UV Matrix LED 3x5x3W 400nm
- power supply 5v 12V
- two metal rods
- Endstop
Software:
- NanoDLP - mode Movement GPIOs
Parameters:
- x/y 0.135mm
- Layer Thickness = 0.05mm
- Cure Time = 2 seconds
- Lift 3mm
- FunToDo Snow White Resin
For details, see:
UV LCD SLA 3D Printer working
UV LCD SLA 3D Printer - presentation
thingiverse:
Hardware:
- Raspberry PI 3
- LCD 5 inch 800x480 HDMI
- Drivers drv8825 (Microstep=16)
- Stepper+threaded rod
- UV Matrix LED 3x5x3W 400nm
- power supply 5v 12V
- two metal rods
- Endstop
Software:
- NanoDLP - mode Movement GPIOs
Parameters:
- x/y 0.135mm
- Layer Thickness = 0.05mm
- Cure Time = 2 seconds
- Lift 3mm
- FunToDo Snow White Resin
For details, see:
UV LCD SLA 3D Printer working
UV LCD SLA 3D Printer - presentation
thingiverse: