My plywood printer
Posted: Tue May 19, 2015 10:09 am
Hi
I have just finished my printer. Principle as b9creator. The sliding operation is controled by a stepper motor and control board is a ramps-board. I will replace the ramps-board with a board containing only two stepperdrivers because the ramps-board was taken from my ultimaker
And my very first print. Default settings in Creationworkshop. resin is FunToDo standard.
The coin is an american quarter dollar.
Next is to make a smaller vat because most of my prints will be small objects so there is no reason for filling a vat with lots of resin.
/Niels
PS This is maybe the first homebuilt printer in Denmark!
I have just finished my printer. Principle as b9creator. The sliding operation is controled by a stepper motor and control board is a ramps-board. I will replace the ramps-board with a board containing only two stepperdrivers because the ramps-board was taken from my ultimaker
And my very first print. Default settings in Creationworkshop. resin is FunToDo standard.
The coin is an american quarter dollar.
Next is to make a smaller vat because most of my prints will be small objects so there is no reason for filling a vat with lots of resin.
/Niels
PS This is maybe the first homebuilt printer in Denmark!