DIY DLP printer
Posted: Thu Feb 19, 2015 2:29 pm
HI
This is my third time to rebuild this printer.
It can work. But still have some problems in resin tank.
First time, I use silicone and acrylic /glass to build resin tank. It look good until PDMS in to it.
Sylgard 184 can melt silicone.
Then I use acrylic glue to build resin tank.
After only one week, Resin melt glue.
New resin tank burst in my Machine.
Maybe I should build resin tank in FEP film...
This is my third time to rebuild this printer.
It can work. But still have some problems in resin tank.
First time, I use silicone and acrylic /glass to build resin tank. It look good until PDMS in to it.
Sylgard 184 can melt silicone.
Then I use acrylic glue to build resin tank.
After only one week, Resin melt glue.
New resin tank burst in my Machine.
Maybe I should build resin tank in FEP film...