A8creator :)
Posted: Sun Jan 18, 2015 5:58 pm
Hi. This is my rebuild of famous 3d dlp printer. I use 6mm plywood, M4 screws and nuts, 5mm clear acrylic, 3mm acrylic for window, 7*3 mm bearings, 10mm smooth rods, lm10uu, 5mm threaded rod, nema17, ramps, abs printed parts, Acer p1500 full HD projector. I will use Creation workshop, many thanks for it to PacManFan!
All dimensions is equal to original printer, except thickness of sheet acrylics.
Building not finished yet, but it moves very fast. Today I received silgard for VAT, thanks Sergiv. And I plan to experiment with FEP film 0.2-0.3mm.
If I successfully finish it, I will make final editions and will share all files.
At this moment I have only funtodo all 3 types, but it is not so good resin. I do not like it. Next week I hope to receive another resin from Russian chemistry factory in Voronezh. I saw how it works, it's awesome!
So, look at the pictures and do not hesitate to tell your opinion and suggestions.
All dimensions is equal to original printer, except thickness of sheet acrylics.
Building not finished yet, but it moves very fast. Today I received silgard for VAT, thanks Sergiv. And I plan to experiment with FEP film 0.2-0.3mm.
If I successfully finish it, I will make final editions and will share all files.
At this moment I have only funtodo all 3 types, but it is not so good resin. I do not like it. Next week I hope to receive another resin from Russian chemistry factory in Voronezh. I saw how it works, it's awesome!
So, look at the pictures and do not hesitate to tell your opinion and suggestions.