Page 1 of 1
LS3DP - LaserShark 3D SLx Printer Build
Posted: Tue Sep 09, 2014 6:51 am
by stimpy
Re: LS3DP - LaserShark 3D SLx Printer Build
Posted: Tue Sep 09, 2014 10:25 am
by PacManFan
Stimpy,
That looks like a great start!. If I were you, I'd use a Arduino/RAMPs board combo instead of the two-step driver board. I currently do not have support for the two-step board.
Re: LS3DP - LaserShark 3D SLx Printer Build
Posted: Wed Sep 10, 2014 11:11 am
by michel pet
hey i am the vriend stimpy is talking about.
Re: LS3DP - LaserShark 3D SLx Printer Build
Posted: Thu Nov 06, 2014 11:00 am
by mela
Hi,
I have all material
-laser 470nm 300mw
-lasershark
-twostep
-galvo
but I don't understand how to connect them.
Kind Regards
Re: LS3DP - LaserShark 3D SLx Printer Build
Posted: Thu Nov 06, 2014 2:47 pm
by PacManFan
Re: LS3DP - LaserShark 3D SLx Printer Build
Posted: Thu Nov 06, 2014 5:51 pm
by Phife
Re: LS3DP - LaserShark 3D SLx Printer Build
Posted: Fri Nov 07, 2014 6:51 pm
by AndersonTa