Its alive master!!!! it's alive!!!
BUT!! kkk my motor just make noise and don't move nice, if i use comand G0 X0 Y0 Z5 they spining for both sides, 1to up 1 to down, 1to up 1 to down,
i configure my Pololu A4988 Stepper Driver with .40V and Sixteenth step on GBRL
my step motor
i using M5 leadscrew.
cheers!
Angelini
grbl firmware
-
- Posts: 14
- Joined: Sat Feb 14, 2015 10:34 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
- PacManFan
- Site Admin
- Posts: 633
- Joined: Sun Dec 01, 2013 11:44 am
- Location: Ahead of the curve [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: grbl firmware
You may have a wire of your A/B phase switched around. Double check the motor wiring
-
- Posts: 14
- Joined: Sat Feb 14, 2015 10:34 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: grbl firmware
hi packman,
i change stepmotor and works fine, now i fight with creation workshop kkk
eg. i draw a 40mmx40mmx40mm box and in projection stay really big than original.
thx per help soon i'll make on topic with my droplit mod.
cheers!
angelini
i change stepmotor and works fine, now i fight with creation workshop kkk
eg. i draw a 40mmx40mmx40mm box and in projection stay really big than original.
thx per help soon i'll make on topic with my droplit mod.
cheers!
angelini