Build Your Own SLA/SLS

Hi,

I am currently using a peristaltic pump to control my resin-level in my VAT.
The pumps tube is connected to rubber hose.

It seems like the fitting between the two is not 100 % sealed, and I would like to glue those together.
I tried "superglue" but it seemed to dissolve and and once again made a mess on my floor.

Is there some kind of putty or glue you know of to make a long lasting seal for my pump connection?

Regards

I would think silicon would be best.

Silicone adhesives will work. I had used silicone to build some all glass vats. With those I did see that some component of the resin is able to permeate through the silicone though resulting in an oily residue on the outer surface of the silicone. A 2 part epoxy or maybe a PMMA (poly methyl methacrylate) adhesive would be even better, especially one intended for bonding thermoplastics.