Holes in build platform

This is the place to discuss various hardware. Topic include:
- Display devices (Projectors, Lasers & etc..)
- Microcontrollers & RAMPs boards
- Power supplies
- Z-Axis and Tilt assemblies
- etc..
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
bjbustard
Posts: 10
Joined: Wed Nov 12, 2014 7:11 pm
Location: Garnet Valley PA
Contact:

Holes in build platform

Postby bjbustard » Mon Nov 17, 2014 11:16 am

I'm looking for suggestions on how to deal with the holes in the build platform on a top down printer. This image is the bottom of a lego piece that should look a lot different.
Attachments
bedholes.jpg
legotest.jpg
Ben

Still tweaking my Sedgwick

AndersonTa
Posts: 189
Joined: Mon Dec 09, 2013 4:28 pm
Location: Houston, TX
Contact:

Re: Holes in build platform

Postby AndersonTa » Mon Nov 17, 2014 11:48 am

I'd suggest floating the object and putting it on a bed of supports w/ a base. Might have some surface defects, but will be better than the large deformations.
@AndersonHTa


[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable