Hi everyone, I have a KLD-LCD Printer 1260. I needed to use the calibration feature of CW but I am unable to do that as my printer is not connected to laptop continuously. Just to get you familiarize with the hardware and software that are present in KLD-LCD Printer.
Hardware:
1. LCD (same as wanhao d7)
2. HDMI Display board (same as wanhao d7)
3. Power-XYZ Control board (I dont think so if its the same as wanhao d7)
4. Raspberry pi 3
Software:
1. Slicing is done in CW and file is exported as cws(mode: compound path) .
2. Raspberry pi 3 has Photonics3D installed to print cws files
I am able to generate the calibration gcode in CW and save in cws file but when I upload it directly to Raspberry pi it gives the following error shown in image attached.
Please if someone can help me out as I need to use this feature urgently and I am fed up of experimenting multiple prints of the same model just to get perfect resin cure times. It takes a lot of time just to get the perfect cure time.
Maybe it will all work if I could directly connect the printer to my laptop serially through usb just like wanhao d7. I tried doing that as well removing the pi from between and connecting control board cable and hdmi cable directly to laptop. It still didnt work.
Please HELP. Thanks.