CW first run: Z-axis moves, but not on "home"
Posted: Thu Nov 05, 2015 11:07 am
Hi all,
I am just trying to run Creation Workshop for the first time (again)
on a new hardware.
Everything seems to be fine, but when I press the "Z-home" button, the Z-axis does not move downwards to it's home position.
If I click Z -10, it doesn't move either.
If I click Z +10, it DOES move up,
and then down again if I press Z -10 again.
However it never goes further down as it was when I turned everything on.
What I am trying to do is configure the Z Endstop, and for this I need the Z-axis to move down first to position zero.
What's wrong here?
Thank you in advance for any help.
I am just trying to run Creation Workshop for the first time (again)
on a new hardware.
Everything seems to be fine, but when I press the "Z-home" button, the Z-axis does not move downwards to it's home position.
If I click Z -10, it doesn't move either.
If I click Z +10, it DOES move up,
and then down again if I press Z -10 again.
However it never goes further down as it was when I turned everything on.
What I am trying to do is configure the Z Endstop, and for this I need the Z-axis to move down first to position zero.
What's wrong here?
Thank you in advance for any help.