Page 1 of 1
gcode
Posted: Tue Jun 09, 2015 8:42 pm
by transformer
im kinda lost on where to put the gcode mabey someone can help trying to build a wiper ..what I want is z lifts up wiper moves zdown projected image wiper go's back ...kinda thing very new to this...now do I have to delete all this G1{$SlideTiltVal != 0? X$SlideTiltVal:} Z($ZLiftDist * $ZDir) F{$CURSLICE < $NumFirstLayers?$ZBottomLiftRate and add mubers in it place or what...thanks guys
Re: gcode
Posted: Tue Jun 09, 2015 9:31 pm
by PacManFan
Re: gcode
Posted: Tue Jun 09, 2015 10:06 pm
by transformer
thanks ..but the problem is ...lift is fine project image is fine dip is fine but no movement for a wiper ? I have it set to the y axis and moves good in the controls /. is there numbers I need to put in there at all?
Re: gcode
Posted: Tue Jun 09, 2015 10:09 pm
by transformer
pacman I just seen to add it to pre slice do you have anything I can read to fully under stand/learn?
Re: gcode
Posted: Tue Jun 09, 2015 11:27 pm
by PacManFan
Re: gcode
Posted: Thu Jun 11, 2015 7:06 pm
by transformer
ok got it working in both directions
but now beamer is way off big time,....but if I stop using wiper.. z axis and beamer work great together ?anyone?
Re: gcode
Posted: Thu Jun 11, 2015 9:08 pm
by PacManFan