Basic CW questions
Posted: Sun Mar 22, 2015 1:40 am
New to all this...Basic questions:
1. Do I have to close the program to start over or view a new part?
2. Are the inch->mm and mm->inch scale buttons just repeatable scaling multipliers?
3. Is it just me, or does the right menu shuffle back to its home position on each click (in a new area) for everyone?
4. Why do I have to click inch->mm or mm->inch to get my scale correct (it varies, depending on the part)?
What to do?:
1. I go to slice view and only see a black screen with a blank Layer # box.
What have I done?:
1. Some parts have become magnetically attracted to the cursor! When this happens, the parts will not follow in all directions, so the parts unattach but reattach when the mouse hovers above them again. How do I stop this?
thank you
1. Do I have to close the program to start over or view a new part?
2. Are the inch->mm and mm->inch scale buttons just repeatable scaling multipliers?
3. Is it just me, or does the right menu shuffle back to its home position on each click (in a new area) for everyone?
4. Why do I have to click inch->mm or mm->inch to get my scale correct (it varies, depending on the part)?
What to do?:
1. I go to slice view and only see a black screen with a blank Layer # box.
What have I done?:
1. Some parts have become magnetically attracted to the cursor! When this happens, the parts will not follow in all directions, so the parts unattach but reattach when the mouse hovers above them again. How do I stop this?
thank you