Postby Scatterplot » Wed Feb 04, 2015 1:31 am
I'm having a strange issue with my setup- H6510BD with a Prolific USB to Serial controller. It seems like I can only send a few commands (one or two), then the projector stops taking more commands. I'm using the manual control to send the ACER_ON and ACER_OFF commands. I've tried doing some disconnecting and reconnecting but that doesn't seem to fix the issue. Sometimes after reconnecting I'll get a "Projector Driver Not Connected" popup.
This is very strange, as restarting Creation Workshop seems to "reset" something, and I can send commands again. I'm wondering if it's something to do with the projector itself, perhaps?