Page 1 of 2
Creation Workshop 36
Posted: Thu Oct 16, 2014 12:09 am
by PacManFan
Tons of new features for you!
It's been a while since I posted an 'official' build. Version 36 is very stable.
Light correction masks are now supported as well.
Please post any relevant feedback to this thread. Next version should have a bunch of pre-configured machines.
Re: Creation Workshop 36
Posted: Mon Oct 20, 2014 8:07 pm
by MrBaz
Looking good. Slices faster than previous versions.
Re: Creation Workshop 36
Posted: Mon Oct 20, 2014 11:08 pm
by AndersonTa
Is there somewhere you have the list of new features/changes?
Re: Creation Workshop 36
Posted: Tue Oct 21, 2014 3:13 am
by adambx
If I export SVG, does that mean that there is no need for antialiasing anymore since vector display is usually antialiased already?
Cheers
Re: Creation Workshop 36
Posted: Thu Oct 23, 2014 7:26 am
by Leinad78
Re: Creation Workshop 36
Posted: Sat Nov 08, 2014 2:32 pm
by asillybird
Re: Creation Workshop 36
Posted: Mon Nov 10, 2014 8:42 am
by cncbasher
sillybird: what problems errors do you have ?
Re: Creation Workshop 36
Posted: Mon Nov 10, 2014 9:26 am
by cncbasher
is the source for the laser plugin going to be available ?
Re: Creation Workshop 36
Posted: Mon Nov 10, 2014 2:29 pm
by AndersonTa
I'm also noticing much longer slicing times, is this supposed to be the case? Something that used to take a few secs takes 5+min to slice now.
Re: Creation Workshop 36
Posted: Mon Nov 10, 2014 3:56 pm
by PacManFan