Creation Workshop for Uncia
Posted: Fri Aug 01, 2014 11:36 pm
Attention Uncia users:
I've created a version of Creation Workshop (1.0.0.30) that is available for test. This version should support the Uncia printer. Included in this distribution is a new Uncia machine and slicing profile. Creation Workshop will generate GCode as normal during slicing, but during the build process, this GCode will be re-interpreted by the new Uncia driver to control the machine. If you have an Uncia machine, please give this a try and report results into this thread.
Thanks,
-Steve (PacManFan)
I've created a version of Creation Workshop (1.0.0.30) that is available for test. This version should support the Uncia printer. Included in this distribution is a new Uncia machine and slicing profile. Creation Workshop will generate GCode as normal during slicing, but during the build process, this GCode will be re-interpreted by the new Uncia driver to control the machine. If you have an Uncia machine, please give this a try and report results into this thread.
Thanks,
-Steve (PacManFan)