[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 574: sizeof(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 630: sizeof(): Parameter must be an array or an object that implements Countable
Build Your Own SLA/SLS • Importing sliced images to CW

Build Your Own SLA/SLS

A forum dedicated to helping you build your own SLA/SLS-based 3d printer
http://www.buildyourownsla.com/forum/

Importing sliced images to CW

http://www.buildyourownsla.com/forum/viewtopic.php?f=5&t=12636

Page 1 of 1

Importing sliced images to CW

Posted: Thu May 17, 2018 7:30 am
by AnishBall
Hi all,

Is it possible to import sliced images to CW? I am looking to print dual material prints using creation workshop but couldn't understand if it was possible to manually import the pre-sliced images to CW.
Any help would be appreciated.
Thanks
AnishBall
All times are UTC-04:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/