Tiny firmware for DIY DLP 3D-printer
Posted: Sun Jan 08, 2017 3:53 am
Hi!
Working on building my printer, I wrote a simplest firmware for Arduino UNO + CNC shild hardware.
Support:
Z-axis smooth movement
Z-axis manual control buttons
Z motor manual on/off button
Cooler control
Servo control
List of Supported G-Codes
- Motion: G1
- Pause: G4
- Motor on/off: M17, M18
- Cooler on/off: M7(M245), M9(M246)
- Servo control: M3
CNC shild v.3 pinout:
Project on GitHub: https://github.com/3DLab-DLP/jap
Working on building my printer, I wrote a simplest firmware for Arduino UNO + CNC shild hardware.
Support:
Z-axis smooth movement
Z-axis manual control buttons
Z motor manual on/off button
Cooler control
Servo control
List of Supported G-Codes
- Motion: G1
- Pause: G4
- Motor on/off: M17, M18
- Cooler on/off: M7(M245), M9(M246)
- Servo control: M3
CNC shild v.3 pinout:
Project on GitHub: https://github.com/3DLab-DLP/jap