[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 574: sizeof(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 630: sizeof(): Parameter must be an array or an object that implements Countable
Build Your Own SLA/SLS • Can not control Z-axis in CW

Build Your Own SLA/SLS

A forum dedicated to helping you build your own SLA/SLS-based 3d printer
http://www.buildyourownsla.com/forum/

Can not control Z-axis in CW

http://www.buildyourownsla.com/forum/viewtopic.php?f=3&t=4948

Page 1 of 1

Can not control Z-axis in CW

Posted: Fri Jan 29, 2016 3:33 pm
by koom
Helppp :cry:
I can jog Z in Gbrl controller.
But I can't control Z axis in CW. I click turn on motor and click +Z to -Z
.....nothing happen.
What is the problem? :?:

Re: Can not control Z-axis in CW

Posted: Fri Jan 29, 2016 6:22 pm
by mike111
Hi I had the same problem try version 1.0.0.54

Re: Can not control Z-axis in CW

Posted: Mon Feb 01, 2016 7:46 am
by koom
Problem Fixed...
I'ts my fault, i try to move motor without machine connecting - -"
i don't know that i have to connect first.
What ever ,Thank you :P
All times are UTC-04:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/