hi all new to the group ...
ive been following this group for a while now and in that time ive been building a dlp 3d printer my problem is
no matter how much I read I cant get the light bulb in my head to turn on when it comes to setting up marlin or sprinter. and how to get the z axis going... im looking for some one to help me under stand this .... please help here's my email if needed hiddenlayersairbrushing@gmail.com mabey some can one on one guide me on this Thanks...
im very good at the design stage but not the codes YET
fimeware z axis all of it? help ?
-
- Posts: 13
- Joined: Sat Jun 06, 2015 11:17 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
-
- Posts: 159
- Joined: Thu Jan 01, 2015 2:56 pm [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: fimeware z axis all of it? help ?
https://www.dropbox.com/s/xc06nixf2xkpg ... 1.zip?dl=0
this is my working marlin firmware. if Z motor not working with this firm, you should check electronic side, ramps, cabling, power supply, etc ...
this is my working marlin firmware. if Z motor not working with this firm, you should check electronic side, ramps, cabling, power supply, etc ...
-
- Posts: 13
- Joined: Sat Jun 06, 2015 11:17 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: fimeware z axis all of it? help ?
thank you is it ok to have two endstops max height and min?
-
- Posts: 13
- Joined: Sat Jun 06, 2015 11:17 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: fimeware z axis all of it? help ?
every time I try to upload marlin to the board it just hangs for ever.. lost sorry
-
- Posts: 10
- Joined: Mon Jan 19, 2015 6:55 pm [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: fimeware z axis all of it? help ?
try sprinter. that's what I use. Everything runs smooth.