Page 6 of 7
Re: How to move CW stepper motors?
Posted: Thu Feb 19, 2015 6:06 pm
by dalaura10
Pac Man Fan
Only you can save us
If you can, look fondly at this issue and give us a light.
Re: How to move CW stepper motors?
Posted: Thu Feb 19, 2015 6:28 pm
by PomeroyB
Re: How to move CW stepper motors?
Posted: Sun Feb 22, 2015 8:24 pm
by dalaura10
PomeroyB
First thank you for your attention
I'm uasando the Arduino Mega
I'm using Dlpsidewinder
I'm not using Marlin, because I could never install it
As for the engines, these are correct, because I can print perfectly only with CW v03 version, which is not I move the jog and work with a newer version.
I'll put some pictures of my impressions.
Att
Dall Aura
Re: How to move CW stepper motors?
Posted: Sun Feb 22, 2015 11:38 pm
by PomeroyB
Re: How to move CW stepper motors?
Posted: Mon Feb 23, 2015 4:51 pm
by dalaura10
Pomeroy
It is this well!
I also suspected that it is unique to the CW3
With greater certainty that want to migrate to Marlin.
I spent the weekend trying to work with Marlin, but could not. I did not find where to set the pins of the stepper motors.
But in the end, I'm really wanting to work with Marlin
How do I start:
Which version should I use ....
have any printer SLA ...
let's move on.
ABRC
Re: How to move CW stepper motors?
Posted: Mon Feb 23, 2015 5:40 pm
by dalaura10
umas imagens de impressão com 50 microns
tanto no Z como no X eY
Re: How to move CW stepper motors?
Posted: Mon Feb 23, 2015 10:40 pm
by PomeroyB
Re: How to move CW stepper motors?
Posted: Tue Feb 24, 2015 12:47 am
by PacManFan
You rock Brandon! Thanks for help out with all the guides.
-S
Re: How to move CW stepper motors?
Posted: Wed Feb 25, 2015 11:55 am
by dalaura10
Re: How to move CW stepper motors?
Posted: Wed Feb 25, 2015 1:00 pm
by PomeroyB