Hi PacManFan,
I have buy one of Pryntech printer. I also have problem with software control, I have use creation workshop to control my DLP printer .it's fantastic.
I volunteer to test your creation workshop for SLA printer. I will order LaserShark with 2 step module to try. please update me when the software is ready to test
at spansupa@hotmail.com
regards
sontaya
Laser SLA reprap
-
- Posts: 7
- Joined: Mon Aug 04, 2014 4:44 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: Laser SLA reprap
Hi PacManFan,
I am going to buy a lasershark board to build a laser SLA. Will lasershark and stepper motors be controlled by RAMPS or it required the twosteps board as well?
Thanks.
Regards,
Savio
I am going to buy a lasershark board to build a laser SLA. Will lasershark and stepper motors be controlled by RAMPS or it required the twosteps board as well?
Thanks.
Regards,
Savio
- PacManFan
- Site Admin
- Posts: 633
- Joined: Sun Dec 01, 2013 11:44 am
- Location: Ahead of the curve [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: Laser SLA reprap
It works with a LaserShark board and RAMPs board. The Twostep board isn't required.
-
- Posts: 11
- Joined: Tue Dec 24, 2013 5:35 pm [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: Laser SLA reprap
I am new to Laser SLA Hopping to get more ideal on the setup and the electronic component that needed to assemble a full set of Laser system. Can any one lend me finger and point me to a good page which to know more.
Thanks
Thanks