Little RP2 - Print Height
Posted: Fri Jul 28, 2017 1:07 am
Howdy everyone,
I had an issue of someone plugging the stepper driver in the wrong way. (blowing up no only the stepper driver but the uno also).
I have put GRBL version 0.8a on with the following settings:
GRBL .8a Values for LittleRP w/o Tilt
$0 = 200.00 (steps/mm x)
$1 = 200.00 (steps/mm y)
$2 = 200.00 (steps/mm z)
$3 = 30 (microseconds step pulse)
$4 = 200.00 (mm/min default feed rate)
$5 = 200.00 (mm/min default seek rate)
$6 = 0.10 (mm/arc segment)
$7 = 255 (step port invert mask. binary = 11111111)
$8 = 25.00 (acceleration in mm/sec^2)
$9 = 0.05 (cornering junction deviation in mm)
The issue im now having is the prints are squished flat.
Also there seems to be a very small potentiometer on the Stepper Driver am i meant to adjust this?
Please help me!
Thank you.
I had an issue of someone plugging the stepper driver in the wrong way. (blowing up no only the stepper driver but the uno also).
I have put GRBL version 0.8a on with the following settings:
GRBL .8a Values for LittleRP w/o Tilt
$0 = 200.00 (steps/mm x)
$1 = 200.00 (steps/mm y)
$2 = 200.00 (steps/mm z)
$3 = 30 (microseconds step pulse)
$4 = 200.00 (mm/min default feed rate)
$5 = 200.00 (mm/min default seek rate)
$6 = 0.10 (mm/arc segment)
$7 = 255 (step port invert mask. binary = 11111111)
$8 = 25.00 (acceleration in mm/sec^2)
$9 = 0.05 (cornering junction deviation in mm)
The issue im now having is the prints are squished flat.
Also there seems to be a very small potentiometer on the Stepper Driver am i meant to adjust this?
Please help me!
Thank you.