Little RP2 - Setup and issues
Posted: Thu Jun 08, 2017 2:10 am
Hey everyone,
I have received my Little RP2 the extended height and build area version. Managed to set it up (probably incorrectly).
I have been using B9 Black resin, and the project is the Acer X152H
My main issue is when im trying to focus the projector (Acer X152H) i'm unable to get all of the focus lines square and to fit in the actual build area.
I also dont think i should have to have the projector like this.
And there seems to be a few to many left overs :O
Would also like to know where i can get replacement film and foam for the vat.
Find a few prints i have done here.
http://imgur.com/a/iMBVa
Cheers
I have received my Little RP2 the extended height and build area version. Managed to set it up (probably incorrectly).
I have been using B9 Black resin, and the project is the Acer X152H
My main issue is when im trying to focus the projector (Acer X152H) i'm unable to get all of the focus lines square and to fit in the actual build area.
I also dont think i should have to have the projector like this.
And there seems to be a few to many left overs :O
Would also like to know where i can get replacement film and foam for the vat.
Find a few prints i have done here.
http://imgur.com/a/iMBVa
Cheers