Uneven build issues.

Forum dedicated to discussion and technical support centered around the LittleRP affordable, open source 3D resin printer.
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
hirenashra
Posts: 59
Joined: Sun Mar 13, 2016 3:25 am
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Uneven build issues.

Postby hirenashra » Wed Apr 12, 2017 4:21 pm

Hi all!

Using waxcast and encountering this issue on uneven builds. It also happens on B9 Yellow so must be a hardware issue.

Got any ideas on more accurate builds?

You can see the wavy bottom of the halo collet. I've noticed this on other prints too.

20170412_211509.jpg

oliveenchine
Posts: 30
Joined: Tue Feb 04, 2014 9:57 am
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Re: Uneven build issues.

Postby oliveenchine » Thu Apr 13, 2017 8:25 am

You should be able to solve this issue by tilting a few degrees on X or Y your model , just consider the first layer of the halocollet is/are very thin so it remain flexible , when you lift/peel and go back on you vat floor the first layers ( 1-3 depending on you layer thickness ) will be very easy to deform and keep some extra resin in between that will be cured ...
other option is to give a long settle time before exposure on those critical/sensitive layer.


[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable