Re: LittleRP2 Information
Posted: Sat Apr 29, 2017 1:09 am
The one thing I did notice are the holes for the projector are not labled. Do you plan on updating your resorces to reflect this?
Oh, and what shims tend to work best for 25 micros?
Thanks!
Also the Z arm doesn't move and it was connected prior to the power and USB. What's an easy way to make sure the software is installed correctly and there is no issue with the board?
Oh, and what shims tend to work best for 25 micros?
Thanks!
Also the Z arm doesn't move and it was connected prior to the power and USB. What's an easy way to make sure the software is installed correctly and there is no issue with the board?