[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 574: sizeof(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 630: sizeof(): Parameter must be an array or an object that implements Countable
Build Your Own SLA/SLS • prints pulling divots out of PDMS

Build Your Own SLA/SLS

A forum dedicated to helping you build your own SLA/SLS-based 3d printer
http://www.buildyourownsla.com/forum/

prints pulling divots out of PDMS

http://www.buildyourownsla.com/forum/viewtopic.php?f=19&t=5681

Page 1 of 1

prints pulling divots out of PDMS

Posted: Thu Feb 02, 2017 10:38 am
by jon_bondy
I just started using FTD's black resin. I like the prints, but some of the smaller prints are pulling small chunks out of the PDMS, ruining the petri dish very quickly. Has anyone else seen this before? Any thoughts about how to avoid this?

Thanks!

Jon

Re: prints pulling divots out of PDMS

Posted: Fri Feb 03, 2017 10:22 pm
by goopyplastic
viewtopic.php?t=5311

Also, HTL's redesign should cure some of the dislikes people had with flexvats:
viewtopic.php?f=11&t=5668&p=16536
All times are UTC-04:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/