prints pulling divots out of PDMS

Forum dedicated to discussion and technical support centered around the LittleRP affordable, open source 3D resin printer.
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
jon_bondy
Posts: 78
Joined: Tue Jun 16, 2015 10:55 pm
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

prints pulling divots out of PDMS

Postby jon_bondy » Thu Feb 02, 2017 10:38 am

I just started using FTD's black resin. I like the prints, but some of the smaller prints are pulling small chunks out of the PDMS, ruining the petri dish very quickly. Has anyone else seen this before? Any thoughts about how to avoid this?

Thanks!

Jon

goopyplastic
Posts: 236
Joined: Sat Mar 29, 2014 6:16 pm
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Re: prints pulling divots out of PDMS

Postby goopyplastic » Fri Feb 03, 2017 10:22 pm

viewtopic.php?t=5311

Also, HTL's redesign should cure some of the dislikes people had with flexvats:
viewtopic.php?f=11&t=5668&p=16536


[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable