Where to source the frame parts from?
Posted: Tue Jan 24, 2017 11:26 am
by sealclubber
I tried to upload the dxf files found on the technical support page to ponoko and it failed, saying that the stroke colors were wrong, and I'm not sure what other alternatives I can use. Has anyone else been in this situation before?
Re: Where to source the frame parts from?
Posted: Tue Jan 24, 2017 1:14 pm
by goopyplastic
I have ponoko ready files available:
https://www.dropbox.com/sh/3fkgu1vmui0f ... ficpa?dl=0They have pretty specific requirements regarding stroke width and colors so it can be a pain to get going the first time.
Re: Where to source the frame parts from?
Posted: Tue Jan 24, 2017 1:55 pm
by sealclubber
Thank you very much for your help!