How to configure firmware/software for tilt option?
Posted: Sat Jul 09, 2016 12:24 pm
I have got my CNC Shield recently. But no luck with making it work properly.
Z-axis is good, but Y (tilt-axis) is unreachable from CW.
I am using Creation Workshop RC54 for Tilt. As was said here , I had set some new GBRL parameters: $1 = 415.00 and $7 = 128.
Then, when I try to operate Z and Y axis from GBRL Panel software, they both are actually working fine. But, when I try to use control buttons in CW, I can't move Y-axis.
What did I missed?
Z-axis is good, but Y (tilt-axis) is unreachable from CW.
I am using Creation Workshop RC54 for Tilt. As was said here , I had set some new GBRL parameters: $1 = 415.00 and $7 = 128.
Then, when I try to operate Z and Y axis from GBRL Panel software, they both are actually working fine. But, when I try to use control buttons in CW, I can't move Y-axis.
What did I missed?