[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 574: sizeof(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/phpbb/session.php on line 630: sizeof(): Parameter must be an array or an object that implements Countable
Build Your Own SLA/SLS • Super adhesion free release bed

Build Your Own SLA/SLS

A forum dedicated to helping you build your own SLA/SLS-based 3d printer
http://www.buildyourownsla.com/forum/

Super adhesion free release bed

http://www.buildyourownsla.com/forum/viewtopic.php?f=19&t=4981

Page 1 of 1

Super adhesion free release bed

Posted: Wed Mar 16, 2016 10:49 pm
by Scentapio
Hi Guys, I just wanted to share with you this Build Plate I just modified, since I did this my adhesion failures have been reduced to 0%
http://imgur.com/iF62nYa
http://imgur.com/StHYj3F
Image
Image
drilled 1.5mm holes in an 5-5mm array. Then I grinded the surface with a broken drill bit.

Re: Super adhesion free release bed

Posted: Thu Mar 17, 2016 12:55 pm
by tom-res
I've found that drilling holes into the build plate and hitting it with some 320 grit sandpaper (without scratching the surface this aggressively) is enough. Never had any adhesion issues.
All times are UTC-04:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/