Super adhesion free release bed

Forum dedicated to discussion and technical support centered around the LittleRP affordable, open source 3D resin printer.
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Scentapio
Posts: 1
Joined: Sun Feb 22, 2015 11:24 am
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Super adhesion free release bed

Postby Scentapio » Wed Mar 16, 2016 10:49 pm

Hi Guys, I just wanted to share with you this Build Plate I just modified, since I did this my adhesion failures have been reduced to 0%
http://imgur.com/iF62nYa
http://imgur.com/StHYj3F
Image
Image
drilled 1.5mm holes in an 5-5mm array. Then I grinded the surface with a broken drill bit.

tom-res
Posts: 19
Joined: Sun Feb 09, 2014 9:55 pm
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Re: Super adhesion free release bed

Postby tom-res » Thu Mar 17, 2016 12:55 pm

I've found that drilling holes into the build plate and hitting it with some 320 grit sandpaper (without scratching the surface this aggressively) is enough. Never had any adhesion issues.


[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable