improvement I need.

Forum dedicated to discussion and technical support centered around the LittleRP affordable, open source 3D resin printer.
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
RedBeard
Posts: 15
Joined: Tue Feb 28, 2017 9:51 pm
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

improvement I need.

Postby RedBeard » Sat Dec 16, 2017 5:09 pm

I was wondering if the crack in the acrylic is effecting these prints. I need to up the cure time, however I don't have had barely any free time. Here are some failed prints. I am using mackerjuice g+. With about 2000ms per layer with brightness @50% on an x152h.

goopyplastic
Posts: 236
Joined: Sat Mar 29, 2014 6:16 pm
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Re: improvement I need.

Postby goopyplastic » Thu Jan 18, 2018 7:56 pm

What are your base and layer times? I'm not famliar with what version of g+ this is, is this the for moonray version?


[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable