Super adhesion free release bed

Forum dedicated to discussion and technical support centered around the LittleRP affordable, open source 3D resin printer.
Post Reply
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Scentapio
Posts: 1
Joined: Sun Feb 22, 2015 11:24 am
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Super adhesion free release bed

Postby Scentapio » Wed Mar 16, 2016 10:49 pm

Hi Guys, I just wanted to share with you this Build Plate I just modified, since I did this my adhesion failures have been reduced to 0%
http://imgur.com/iF62nYa
http://imgur.com/StHYj3F
Image
Image
drilled 1.5mm holes in an 5-5mm array. Then I grinded the surface with a broken drill bit.
Top
tom-res
Posts: 19
Joined: Sun Feb 09, 2014 9:55 pm
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Re: Super adhesion free release bed

Postby tom-res » Thu Mar 17, 2016 12:55 pm

I've found that drilling holes into the build plate and hitting it with some 320 grit sandpaper (without scratching the surface this aggressively) is enough. Never had any adhesion issues.
Top
Post Reply
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Return to “LittleRP”