Hello and some troubleshoot advice
Posted: Tue Sep 22, 2015 2:53 am
Hello all! I recently got my new littlerp and my first 2 calibrations
The solid 123ABC block printed the 3 largest rods, but they were slightly merged and broke off while I was alcohol washing them. The other print was supposed to be a 5mm step and clearly did not print well at all. A second half was disconnected and sitting in the resin bed when I came back to check on the print. Any ideas on fixes or what I've done wrong?
The solid 123ABC block printed the 3 largest rods, but they were slightly merged and broke off while I was alcohol washing them. The other print was supposed to be a 5mm step and clearly did not print well at all. A second half was disconnected and sitting in the resin bed when I came back to check on the print. Any ideas on fixes or what I've done wrong?