Build Your Own SLA/SLS

Here's a micro Marvin...I think he's about 2mm tall.

Your website is not showing on my android?

Cerrious,
I had the same issue with Chrome. I googled refiy-3d and it gave me the same exact address but it worked.
Great looking printer by the way...

Thanks, I fixed the link.

We've made a couple firmware and hardware upgrades recently and I'm very happy with the results:




Mark

The ring and the pineapple were both printed with B9 cherry.

43mm tall Spartan modeled by Scythe and printed at 25 XY and Z. It's been a long, long road to get here, but now we're getting the print quality I've always dreamed of. Thank you Steve for making this possible.

Hi,

What you make to archive this beautiful result?
You say hardware, better projector? Better z axis? Better optic? Or vat?
And what is so important in the firmware than can change the result to that?!
You use CW no?
And 25um is very small, maybe enough to answer all this questions...
A lot of questions but I hope is not to much...
Thanks!