Page 1 of 2
Stalactite is here!!!
Posted: Wed Apr 23, 2014 7:27 am
by fleming
Finally, after many months, the crow-founding champaign had been launched:
Congrats PacManFan, the software seem awesome!!
Regards
Re: Stalactite is here!!!
Posted: Wed Apr 23, 2014 10:46 am
by PacManFan
Re: Stalactite is here!!!
Posted: Wed Apr 23, 2014 12:31 pm
by AndersonTa
Congrats, Steve...thought the software looked familiar!
Man the conversion from euros to USD hurts...damn weak dollar!
Re: Stalactite is here!!!
Posted: Wed Apr 23, 2014 1:00 pm
by Finhead
Software looks very nice great job Steve.
Foe the price I would have expected a larger build area but it's not bad, using round linear rails makes it far cheaper to build mind you.
From the looks of there video they seem to b using the same peel technique as the mUVe1 printer kind of a pull from one side/one axis.
Clinton
Re: Stalactite is here!!!
Posted: Wed Apr 23, 2014 5:05 pm
by fleming
@pacmanfan... sorry for overtake you on the rigth lane....
but you can still prepare a new post with your impressions on the machine and the project
@Finhead, they uses two Acme leadscrews at each side, with two steppers, they implement the tilt in the Z axis. In the first prototype, they had belt transmission for the Z-axis...
Regards
Re: Stalactite is here!!!
Posted: Wed Apr 23, 2014 7:44 pm
by Finhead
Re: Stalactite is here!!!
Posted: Thu Apr 24, 2014 1:35 am
by fleming
Also in the timelapse of the building, you will realize on the tilting of the piece (and not on the Vase)...
Re: Stalactite is here!!!
Posted: Thu Apr 24, 2014 1:48 am
by Finhead
Re: Stalactite is here!!!
Posted: Thu Apr 24, 2014 10:56 am
by PacManFan
Re: Stalactite is here!!!
Posted: Thu Apr 24, 2014 11:01 am
by Finhead