Page 6 of 8
Re: Flex bottom VAT
Posted: Sun Oct 19, 2014 6:03 pm
by chemstar
awesome idea by the way hp using a Tupperware container
Re: Flex bottom VAT
Posted: Mon Oct 20, 2014 10:41 am
by dangre
FEP is tough stuff. I accidentally drove my Z home with a 15mm diameter printed shaft on my build plate (again). By the time I could hit the power switch it had driven about 25mm into the 0.005" FEP. It permanently deformed the FEP but did not break through.
Re: Flex bottom VAT
Posted: Mon Oct 20, 2014 1:00 pm
by hp_
dangre,
here you see, 400% stretch makes that possible
thanks for sharing
i had many similar experiences
Re: Flex bottom VAT
Posted: Tue Oct 21, 2014 4:56 pm
by Excited4DLP
Re: Flex bottom VAT /OVEN BAGS
Posted: Wed Oct 22, 2014 12:01 pm
by SIDRANA
The Turkey Oven Bags
Re: Flex bottom VAT/ THE BAGS
Posted: Wed Oct 22, 2014 12:26 pm
by SIDRANA
Comes off like a butter
Re: Flex bottom VAT/ THE BAGS
Posted: Wed Oct 22, 2014 3:22 pm
by PacManFan
Re: Flex bottom VAT/ THE BAGS
Posted: Wed Oct 22, 2014 4:03 pm
by Excited4DLP
Re: Flex bottom VAT
Posted: Wed Oct 22, 2014 4:49 pm
by SIDRANA
Hello
Actually the resin is; directly from the bottle to test the film; As of now I am making the FLEX-VAT from a container,
and going to foil the bottom part corners away, rather than cutting it to have a clean surface .
Regards
Saeed
Re: Flex bottom VAT
Posted: Wed Dec 03, 2014 8:38 am
by Excited4DLP