Research: Breaking force needed for release?
Posted: Wed May 21, 2014 6:48 am
hello guys,
i´ve been very busy the last weeks and i´m still busy right now and the next weeks, but i´m trying to digg into the coating a bit deeper.
i may have found a solution which could be helpfull, but i need some input first for testing purpose.
does anyone have made/seen measurements of how much drag is needed to break off the printed parts from an uncoated and different coated glasses? lets say per square inch or even better cm²
does it matter how thick the layer is? from simple thinking about it, i´d say no.
kind regards and thanks for input.
i´ve been very busy the last weeks and i´m still busy right now and the next weeks, but i´m trying to digg into the coating a bit deeper.
i may have found a solution which could be helpfull, but i need some input first for testing purpose.
does anyone have made/seen measurements of how much drag is needed to break off the printed parts from an uncoated and different coated glasses? lets say per square inch or even better cm²
does it matter how thick the layer is? from simple thinking about it, i´d say no.
kind regards and thanks for input.