Arduino connecting schematics
Posted: Thu Aug 13, 2015 8:05 am
Hi there,
First of all, thanks for the creators of this board ! Without them, I'd never waist my time/lose my money/have so much fun to build a 3D printer.
I'm French, so excuse me if my language looks awful or funny.
So, my firt question here will be about the Arduino. I'm totally noob concerning this type of hardware. I read that I have to use a Mega 2560, and install on it a firmware, Splinter or Marlin. It doesn't look easy but I'll try and come back here to cry if I fail. But were can I find some electronical schematics? I have an unusual motor driver (Oriental Motor CSD2109-T, datasheet ) wich seems working as an EasyDriver ; 5V inputs for Pulses, Direction an Enable fonctions.
So, to resume my question : where do I have to connect the wires on a Arduino ?
First of all, thanks for the creators of this board ! Without them, I'd never waist my time/lose my money/have so much fun to build a 3D printer.
I'm French, so excuse me if my language looks awful or funny.
So, my firt question here will be about the Arduino. I'm totally noob concerning this type of hardware. I read that I have to use a Mega 2560, and install on it a firmware, Splinter or Marlin. It doesn't look easy but I'll try and come back here to cry if I fail. But were can I find some electronical schematics? I have an unusual motor driver (Oriental Motor CSD2109-T, datasheet ) wich seems working as an EasyDriver ; 5V inputs for Pulses, Direction an Enable fonctions.
So, to resume my question : where do I have to connect the wires on a Arduino ?