Getting Started, Controller
Posted: Wed Feb 19, 2014 8:16 pm
Hello the SLA World.
Thanks to Mr. Steve, for this outstanding Creation-works software. Apart from the electronic everything from designs to fabrication is my forte. I am in my sixties now. Fifty years ago I did very little soldering building up radios for my neighborhood friends. Today I have soldered electronic components and successfully assembled the controller. My point is that it can be done in a day's time and within the budget of US hundred Dollars.
It is based on Arduino UNO R3, $ 30.00
DK Electronics Stepper Motor Driver, $ 8.00
Sprout un-assembled Break out Mother Board. $ 19.00
Two Power supplies. $ 11.00
Aviation Connecting Plug GX10 $ 30.00
I still have to configure the Firmware. Maybe the only Glitch.
Please correct me, I intend to use 6mm optical glass for the VAT. Bottom Up System.
I could have Finnish the controller today, but for some reason I cannot find my 10mm drill bit, well this project will be done by next week now.
Regards
Sid
Thanks to Mr. Steve, for this outstanding Creation-works software. Apart from the electronic everything from designs to fabrication is my forte. I am in my sixties now. Fifty years ago I did very little soldering building up radios for my neighborhood friends. Today I have soldered electronic components and successfully assembled the controller. My point is that it can be done in a day's time and within the budget of US hundred Dollars.
It is based on Arduino UNO R3, $ 30.00
DK Electronics Stepper Motor Driver, $ 8.00
Sprout un-assembled Break out Mother Board. $ 19.00
Two Power supplies. $ 11.00
Aviation Connecting Plug GX10 $ 30.00
I still have to configure the Firmware. Maybe the only Glitch.
Please correct me, I intend to use 6mm optical glass for the VAT. Bottom Up System.
I could have Finnish the controller today, but for some reason I cannot find my 10mm drill bit, well this project will be done by next week now.
Regards
Sid