Build Your Own SLA/SLS

Hello the SLA World.



Thanks to Mr. Steve, for this outstanding Creation-works software. Apart from the electronic everything from designs to fabrication is my forte. I am in my sixties now. Fifty years ago I did very little soldering building up radios for my neighborhood friends. Today I have soldered electronic components and successfully assembled the controller. My point is that it can be done in a day's time and within the budget of US hundred Dollars.



It is based on Arduino UNO R3, $ 30.00

DK Electronics Stepper Motor Driver, $ 8.00

Sprout un-assembled Break out Mother Board. $ 19.00

Two Power supplies. $ 11.00

Aviation Connecting Plug GX10 $ 30.00





I still have to configure the Firmware. Maybe the only Glitch.

Please correct me, I intend to use 6mm optical glass for the VAT. Bottom Up System.



I could have Finnish the controller today, but for some reason I cannot find my 10mm drill bit, well this project will be done by next week now.



Regards

Sid

looking good, Would you add links to the parts, so we can see what you refer to.