SubG+ exposing time at 100µm and Acer H6510BD min. 10s?

You can discuss Photo-sensitive resins, polymers, and oligomers.
Leinad78
Posts: 102
Joined: Wed Dec 04, 2013 3:39 am

SubG+ exposing time at 100µm and Acer H6510BD min. 10s?

Postby Leinad78 » Sat Mar 21, 2015 5:29 am

hello guys,

i´m really curious about the time i need to expose a 100µm layer of SubG+ when using the Acer H6510BD. It takes at least 10s to cure such a layer, even at full power mode. Is it depending so much on the resin as i have read that FunToDo resin needs roughly 1-1.5s to cure the same layer? :shock:

If i´m exposing a 100µm layer by only ~5s, the surface is somekind of waxy, even after curing it several hours in an uv-light oven. :(

Your input is highly appreciated

james_lan
Posts: 8
Joined: Fri Apr 10, 2015 10:06 pm

Re: SubG+ exposing time at 100µm and Acer H6510BD min. 10s?

Postby james_lan » Sun Apr 19, 2015 3:38 am

I have a P1500 (Which per the Acer site uses the same bulb and a LittleRP (KS version))

I've got a thread on the LittleRP regarding my experiments with (Sub)G+ and the P1500. It cures REALLY fast compared to MakeSolid Red (or the times for SubSF)

viewtopic.php?f=19&t=2905

I'm planning after the batch of Purple is done to try pure blue again, with even lower times. Hope this helps you.


Return to “Resins”

Who is online

Users browsing this forum: No registered users and 1 guest