investment casting
Posted: Mon Nov 03, 2014 9:51 pm
I'm a complete newb when it comes to SLA printing, so I'm glad to find this board. I'm looking to make prints for investment casting and I'm hoping some of you out there have some recent experience with some of the casting resins.
Thus far I've been recommended the b9-1 Red. Does anyone have experience with that resin, or with the Firecast from Madesolid, or the Form1 Castable resin? This would be for jewelry level detail and casting. I'm using a Muve-DLP.
Also, I haven't yet come across any "sla 101" as far as post build cleanup, cure times, use a UV oven or not, etc.
Thanks!
Thus far I've been recommended the b9-1 Red. Does anyone have experience with that resin, or with the Firecast from Madesolid, or the Form1 Castable resin? This would be for jewelry level detail and casting. I'm using a Muve-DLP.
Also, I haven't yet come across any "sla 101" as far as post build cleanup, cure times, use a UV oven or not, etc.
Thanks!