Heated Resin
Posted: Mon Oct 06, 2014 10:15 am
Hi,
I just bought some SubG+ for my top-down printer.
Since I am not using a wiper or other contraption I worry about surface tension to mess up my prints.
I was thinking of heating the resin, but then there is the question : what temperature would be right?
At first I thought viscosity was correlated to surface tension, but apparently not
http://www.cscscientific.com/csc-cienti ... -Viscosity
Has anyone tried this, and does it make any difference?
I just bought some SubG+ for my top-down printer.
Since I am not using a wiper or other contraption I worry about surface tension to mess up my prints.
I was thinking of heating the resin, but then there is the question : what temperature would be right?
At first I thought viscosity was correlated to surface tension, but apparently not
http://www.cscscientific.com/csc-cienti ... -Viscosity
Has anyone tried this, and does it make any difference?