resin failure
Posted: Sat Jun 14, 2014 4:18 am
Hello everyone,
I have suddenly hit some issues with resin builds not working after about 8mm or so - it can vary.
I have tried to attach photo.
The resin is b9 red very sticky, these were built at 0.03mm in bottom up machine using creation workshop software.
Only recently it seems to have happened, it seems to be happening with other resins as well, maker juice,and spot materials.
The only change I can think of is I have been casting a bit more in the same environment so the ambient temperature has increased.
Thanks Simon
Sorry cannot upload image at the moment, says file type (jpg) not allowed. Its below the maximum.
I have suddenly hit some issues with resin builds not working after about 8mm or so - it can vary.
I have tried to attach photo.
The resin is b9 red very sticky, these were built at 0.03mm in bottom up machine using creation workshop software.
Only recently it seems to have happened, it seems to be happening with other resins as well, maker juice,and spot materials.
The only change I can think of is I have been casting a bit more in the same environment so the ambient temperature has increased.
Thanks Simon
Sorry cannot upload image at the moment, says file type (jpg) not allowed. Its below the maximum.